F4HIK-LAB I2C HUB 1×5 — board only
Dimensions : 62 × 18 mm
Assembled electronic board distributing one I2C bus input to five outputs. Fitted with six 4-pin JST-XH headers. Housings, contacts and cables are not included.
Official shop
Azimut One
DC and AC consoles configured for your rotor, accessories and electronic boards. Choose your product, then your secure payment method.
DC 24 VAC 115/230 VUDP directWi-Fi + LAN
Electronics only
Standalone electronic boards
F4HIK-LAB I2C HUB 1×5 — with connectors
Dimensions : 62 × 18 mm
Assembled electronic board distributing one I2C bus input to five outputs. Fitted with six 4-pin JST-XH headers. Supplied with six 4-pin JST-XH housings and 24 crimp…
View details
Assembled electronic board distributing one I2C bus input to five outputs. Fitted with six 4-pin JST-XH headers. Supplied with six 4-pin JST-XH housings and 24 crimp contacts. Cables are not included and contacts must be crimped by the buyer.
F4HIK-LAB DUAL RS485 I2C
Add two independent RS485 interfaces to your system through a single I2C bus. Each port has its own TVS protection and a jumper-selectable 120 Ω termination. The mod…
View details
Add two independent RS485 interfaces to your system through a single I2C bus. Each port has its own TVS protection and a jumper-selectable 120 Ω termination.
The module uses one SC16IS752 and two MAX3485 transceivers. The two separate lines allow two devices to use the same protocol and RS485 address.
Power supply: 5 V DC through a dedicated connector. Internal logic: 3.3 V. Four selectable I2C addresses: 0x48, 0x49, 0x4C and 0x4D. One I2C address provides access to both UART channels. No galvanic isolation.
The module uses one SC16IS752 and two MAX3485 transceivers. The two separate lines allow two devices to use the same protocol and RS485 address.
Power supply: 5 V DC through a dedicated connector. Internal logic: 3.3 V. Four selectable I2C addresses: 0x48, 0x49, 0x4C and 0x4D. One I2C address provides access to both UART channels. No galvanic isolation.
AC compatibility
Compatible AC rotors: Yaesu G-450C/G-450A, G-600/G-600RC, G-650C/G-650RC/G-1000C and G-2000RC; Kenpro KR-400/KR-400RC, KR-600/KR-600RC and KR-650XL; Hy-Gain HAM-IV, HAM-V and Tailtwister T2X. Other models after technical validation.
Current version: screen 4.31 · WT LAN 1.76.
Prosistel 12/24 V with 3-wire potentiometer supported. 5-wire Hall sensors: not yet available.